新闻中心

新闻中心

NEWS CENTER

[The Most Comprehensive Guide] How to Check Your Car’s Engine Oil Level

Release time:

2018-11-24


Engine oil is the lifeblood of your vehicle, so it’s essential to choose the right type for your car. The market offers a wide variety of oils, typically graded by their viscosity—how thick or thin they are—at different temperatures. The fine print on the label usually specifies the oil’s performance in both hot and cold climates. When deciding which oil to buy, always consult your vehicle’s owner’s manual. You don’t necessarily have to stick with the brand recommended in the manual, but make sure the oil meets the required grade. Using an oil that’s too thick can lead to sludge buildup and reduced engine performance, while an oil that’s too thin may cause premature wear.

Check the oil level by parking the vehicle on a level surface. If parked on a slope, the reading will be inaccurate. After stopping, wait a moment to allow the oil to drain back into the oil pan. Refer to the owner’s manual to locate the dipstick; if no instructions are provided, look for the pull‑out tab protruding from the square housing—this tab may be positioned near the engine. Remove the dipstick, wipe it clean with a lint‑free cloth, reinsert it fully, and then pull it out again. The oil level should fall between the maximum and minimum marks.

 News

 

If you notice water droplets on the dipstick, it indicates that water has entered the engine oil. This is often caused by wear of the engine head gasket, which can ultimately lead to more serious engine damage.

 

 

 

If the oil level is too low, open the oil filler cap and add oil in small increments. Use a clean, sand-free funnel to prevent spills. Wrap a cloth around the oil filler opening to absorb any oil that may leak out. After topping up, be sure to wipe the engine clean.

Do not overfill the engine oil, as this can cause the valves and spark plugs to burn out and may also lead to gasket and oil seal failure.

If regular oil top-ups are required, check for leaks and, if necessary, have a professional inspect the vehicle.

 News

 

Replacing the engine oil and oil filter requires replacing the following components:

 

 

 

The appropriate grade and correct quantity of engine oil (see the owner’s manual), an oil filter wrench, and a clean, lint-free cloth.

The pan used to collect waste oil should be large enough to hold the entire volume of used motor oil, yet shallow enough to be easily placed under the vehicle (or beneath the oil extractor).

New gasket used on the drain plug

 News

 

When draining the engine oil, you can proceed to replace the oil filter. Most new vehicles are equipped with an integrated spin‑on oil filter; simply loosen the screw to remove it (you can unscrew it by hand, and if it’s difficult to take off, use an oil filter wrench). After removing the old filter, clean the mounting area thoroughly, apply a small amount of engine oil to the new filter’s sealing ring, and then tighten it by hand.

 

 

 

Once the new oil filter is installed, the used oil should be almost completely drained. Wipe the area around the drain plug clean and reinstall the plug. Slowly pour in the new oil until it reaches the correct level, which you can check with the dipstick. Wipe up any overflow, then start the engine and inspect both the drain plug and the new oil filter for leaks. Turn off the engine and wait a few moments to allow the oil to settle, then use the dipstick again to verify the oil level. 。

 

 

 News

Older models use cup‑type filters. Loosen the retaining bolts, lift out the filter cup, and pour the oil from inside into an appropriate container. Be sure to note how many spring washers and sealing gaskets were used, and reinstall them in the same order. Discard the old filter element, then clean the filter cup with kerosene. Wipe both the inside and outside of the cup dry, and insert a new filter element. Carefully remove the old rubber sealing ring from the mounting groove on the filter head at the top of the engine; clean and dry the filter head, and install a new sealing gasket. Align the filter cup with the sealing gasket, and while tightening the bolts, hold the cup in place as you secure it.

 

 

Introduction to the Lion Oil Lubricant Brand

 

 News

 

Using fully synthetic lubricants, your engine delivers robust power and stable oil pressure, while extended oil-change intervals help reduce operating costs and prolong engine life.   The cleaning oil contains detergents and dispersants, and is formulated to work with engine oil of the same viscosity to protect your engine, effectively preventing carbon deposits and sludge buildup, ensuring a smoother drive, and extending engine life.

100% imported base oils and additives, blended under fully automated computer control, with comprehensive quality testing. Ensures superior and consistent product performance. .

 News

 News

[The Most Comprehensive Guide] How to Check Your Car’s Engine Oil Level

Latest Updates

When assessing damage to a vehicle that has been flooded, which parts must be replaced, and which can be reused?

Due to recent heavy rainfall in several cities, many vehicles have required repairs after being submerged in water. So how should damage to flood‑damaged cars be assessed? What is the specific repair process for water‑submerged vehicles? And how can you prevent improper repairs?

Happy New Year Start! Back from the Spring Festival—here are some essential car‑care tips you should know!

Before we knew it, the Spring Festival holiday is already over, and the Mengshi team has been back at work for two days now. During the holiday, we visited relatives and friends...

[Lion’s Classroom] All About Wheel Alignment

Wheel alignment is based on the vehicle’s four-wheel parameters and involves adjustments to ensure optimal driving performance and a certain level of reliability...

[Lion’s Classroom] Spark Plug Mini-Class

Our cars have thousands of components, each of which is essential. Yet many drivers focus solely on oil changes during maintenance, overlooking small parts like spark plugs. Today, we’ll show you how to determine for yourself whether your spark plugs need replacing.

[Lion’s Classroom] Handy Tips for Tire Maintenance

A journey of a thousand miles begins with a single step. Tires are like the shoes of a car—their condition directly affects driving safety. That’s why tire safety is of paramount importance, and regular maintenance is essential. Now, let’s take a look with the editor at how to properly care for your car’s tires!

[Lion·Certification] Warmly celebrate the official certification of Lion Lubricants’ 0W-20 series by Volvo!

Recently, Volvo officially awarded Mingshi Lubricants the VCC RBS0-2AE standard certification for its SN 0W20 product. One technological breakthrough after another has once again demonstrated the exceptional quality of Mingshi Lubricants.